Recent content by Radek

Hi All, Can someone tell me the sizes of both end of this filling loop (flexi part)? Is it 1/4 and 1/2?? The part is here...

He is a gsr engineer. He was a bit in a hurry that day but he is a top bloke :) I will tell him tomorrow and it should be easy to do as he will have to put new plate heat exchanger Due to luke warm water :/ Pressure should be ok until he pop in as I was watching it all day and on high heating...

Thank you. I did looked again and it should be 0.5bar. I will set boiler for 1.2 and EV as it should be (0.5) Will this sort high pressure problem? I dont have to drain the boiler? I will have to drain the boiler before changing pressure? I will wait for my plumber so he will do that as I need...

Hmmm I just ordered a new EV for my boiler and plumber did the rest. He just fit a new EV and that was it. He will be back tomorrow so I will tell him about that. The new EV was precharged at 1.5bar and according to boiler manual this 8L Ev should be at 0.75 bar :/ Should I tell him to change...

Yes, I did order it for my glow worm ultracom 30cxi which is 8L EV. Is it something to do with the EV pressure? As I believe it was 1.5bar precharge ( engineer haven’t check it) Is it to much? thanks, Rad

Sorry for that.... When system is cold the pressure is 1bar, and when CH is on and set up to 53C it will go up to 2.4bar for 10 min and after that it will drop to 2.1bar for some time until will have to work hard again to heat up water (2.4bar). I know the pressure should go up but not by...

Hi, Hope that this is the right place for me question. I had a problem with a high pressure and noticed that my prv is leaking after pressure going up to 3bar, also expansion vessel was dead. To solve this the Prv was replaced, pressure sensor as it was reading to high and expansion vessel as...

Hi, Thanks for reply :) - Yes we do have condensation problem but window were open and rooms not overheated. - Previous paint was coming off when I rubbed it with wet finger but I need it to push hard against wall. I have removed all loose paint before sanding. - yes I did wash the walls with...

Hi everyone. I will be grateful for an advice... I just moved in to a house where all the walls were covered with latex like paint which was very easy to remove with wet finger. In my opinion I did all the preparation I should to prepare wall for painting. Because it was kind of a silk/glossy...