Recent content by rajjinator

I am indeed seeing 100% in the diags. I have just removed the internal jumper for the 680 EOL resistor since I have a wiring set up as per "configuration B (Two Chains)" in the manual, and also power cycled the RF portal by removing power. Will try another PIR if issues persist.

Strange. If I had some kind of addressing issue would things just not work at all, or could that be a potential cause? I am using a MK7 keyprox also wired to the 485 bus. Both are in short wire runs directly to the panel and with EOL resistors in place at both portal and keyprox. (not sure if i...

Good to know, thank you. I might try another PIR to see if the problem persists and then perhaps move the portal closer to the outbuilding. But it's perhaps only 15 meters at most. I know it's going through an external wall but i'd expected better. What sort of range might one typically expect...

OK thanks, I will try to physically remove and reinstate power from the portal when this reoccurs whilst in engineer mode. Portal Firmware is indeed V3.00 and the panel firmware is V3.52

Hi GalaxyGuy. That indeed corrects the issue, it's happened twice now within the period of a week and both times rebooting the panel using the option in the engineer menu has corrected the issue. I assume doing this also power cycles the portal. Do you think I am just trying to operate on the...

Hi all, I have DIY installed a Flex 20 with 3 wired zones (1x PIR and 2x Door contacts). All working fine until I recently added an RF portal to the RS485 bus and paired a wireless DT8M PIR for an outbuilding approx 10-15 meters away from the RF portal. This has been working OK for a number of...