Recent content by Randa2007

I have a question which I hope will get a sensible answer. I contacted Gledhill about adding an inhibitor. I was told that it goes in through the header tank but it needs to be partially drained first and refilled after the inhibitor has been added. I do not know how much needs to be added or...

As the one who mentioned the BM2 a few days ago and started this debate, as a consumer with very little knowledge of all matters plumbing, I more than welcome anyone to service my system to see how good or bad it is, free of charge of course as I'm donating the equipment lol

Engineer £50 call out plus hourly rate plus parts . One PCB was definitely dead and the other had a fault so an engineer would have cost much more.

I have boilermate 2 and had the same issue. The delay timer PCB was buzzing so after reading in the forum that the capacitors were at fault, i sourced the 2 units and fitted the first capacitor to the delay timer only for the buzzing to remain. I then thought could the pump PCB be causing the...