Recent content by raymacca

Cheers secureiam Think you live in the same neck of the woods as me seen your van around and about

Thanks for your reply. This is what the manual says. Engineers code Prog then press 05 then 6 All Texecom bell boxes feature a unique, patented "Engineer Hold-Off Mode", which disables Self- Activate the Lid Tamper to facilitate convenient servicing. Option 6 will cause the strobe output to...

Hi everybody Got a Veritas 8 control panel and an Odyssey 1E Bell box, just changed the battery in the panel and want to change the battery in the bell box. Can anyone explain how I can put the bell box into Hold-off mode so I can work on it without the sounder going off? Thanks

Yes thanks anyway secureiam

Yes, I notice that as well the bloke who fitted the alarm 29 years ago must change colour halfway through. yes, zone 2 is the landing PIR blue and yellow. But the good news is you were spot on there was a break in the yellow wire it was trapped between the roof joist and a supporting brick about...

Wired them together still no joy will check the run of wire in the garage some of it looks a bit ropey I will get back to when I've checked it. Thanks

OK tried wiring like said above but no joy when I try and set the alarm the zone 3 on the panel with the new PIR just stays lit and get a constant beeping. Lights on PIR all come on when walking past then go out. Do I need to do a factory reset???

I see thanks for your reply much appreciated

What are these jumpers for can't find any information about this

Thanks again sparkymarka

Thanks sparkymarka Does it matter which way blue and yellow go and do I leave all jumpers as they came as Thanks again

Thanks for your reply

Need to change a 29-year-old PIR in the garage been going off during the night. Got a Texecom premier elite dt afg-0001 to replace the old one need your expert advice on how to wire it. The old one has only 4 wires going into it black/red from aux in the panel and 2 blue/yellow tamp. The...

OK done what you said seems to work fine see how it goes thanks for your help.

The original alarm was done by IAAI Installer 29 years ago, have look in the PIRS and they have two tamp wires and pos /neg