Recent content by RDS25

ok I have rechecked the gas safety register and he is not down as qualified to fit an unvented cylinder also to clarify he has filled out a benchmark for both the boiler and the water cylinder. neither of these were handed to to me and you are quite correct that I have not signed the one...

i am in hertfordshire by the way I have just noticed that in the back of my installation instructions my plumber has completed the benchmark and commissioning checklist, (I was not aware that he had completed this but, as I said he thinks he has finished his work) he has also ticked that...

Norcan, that looks useful it has far more detail on than the instalation instructions I have should I be concerned that this is an american set of instructions?

the boiler is running and heating the house. the hot water is being heated by the immersion (I was told that this was a temp solution that has now been in place for a few months). I have checked with the gas safety register and the plumber is registered with them. However they don't seem...

Thanks Tony, The plumber is gas safety registered and he selected the boiler and cylinder. As far as he is concerned he has finished the job as he has connected the 4 pipes into the boiler but not the electrics to control it (as I said he does not do the electrics). the problem appears to...

my plumber has installed a viessmann vitrodens 200-w which he has plumbed into a Albion ultrasteel hot water cylinder (my plumber does not touch electrics) My electrician has connected an immersion heater to the cylinder but he has now left the area so can not finish the job.. The vitodens...