Recent content by Rendelf

Sketch attached The sump will sit about 50mm below the level of the floor. The entire unit is designed to be a single, movable object. The pipe to pump water out of the sump is to enter it from above. The shower tray is not going to be made in situ, so will be transported to boat and...

Well, tray to be created from marine ply, and sump to be a stainless steel pot...similar to a culinary container (roughly a cube with a lip designed to sit inside a frame - the lip can be bonded to the plywood, and the sump will then offer a small profile to allow water to be pumped effectively)...

Do you mean fibreglass over the concrete? Or would fibreglass allow me to build up smooth curved edges and a fall into one corner of the tray?

Hi all, Current project is building a customised shower for our boat. The design hinges around cheapness, but one that fits into an unusual space. Currently, plan is to create the shower tray from successive layers of marine-ply, glued together and then coated with a marine-grade resin from...