Recent content by rhayward

I've tried to fit the TRV directly on, doesn't fit, used the adaptor that comes in box, doesn't fit and have bought some online but they don't work.. any help would be great, thank you!

https://www.ebay.co.uk/itm/375504318218 I believe this should be it so have ordered with a blanking plate. Hopefully once this is it the Hive system will get the boiler going by itself. Can't wait to try it. Thanks for your help again!

Ah, correct! Is a 3 pin plug and Logic+ Combi C30

Thanks again! So I've unplugged the receiver and can see where number 2 the link plug needs to go. I have a link wire but it's not in a plug so I'll need to buy one of them then but in the meantime I will do as you say and keep the receiver plugged in, turns old thermostat high and try the Hive...

Thank you very much for that! Is there any reason to keep it in place? as happy to remove it but I dont have a blanking plate yet so is it best to wait until I have a blanking plate? Also, could you please check my comment on here just now, is that wiring correct with red link being taken out...

and also I'm meant to take the red loop link out aren't I and then wire in the Hive cables (in this case black and grey) into those two room stat ports like I originally did here on the second picture?

Excellent, thanks for the info! So I'll connect the earth again in receiver and rewire the boiler as I originally did here and so the receiver is the part on the front that says 'signal' and has all of the lights on? Will get the rewiring done and then look at removing that. Take it a...

Here we are, thanks :)

Hello, Thanks so much for your replies! So, the incoming supply I will keep connected, it is reconnected now and working. In regards, to the copper showing, it is clamped and doesn't pull out but regardless, do I need to shorten it so there isn't much showing as if a lot is showing can it...

Hello, so I fit the Hive myself last night, I had all of the 5 core connected in the ports below and then into the Hive receiver. Pics below are how it looked once finished however the ideal thermostat was still working So all cables were matched to where they should be Blue cable - Neutral...

Hello, so as above really, I'm looking to connect my my Hive thermostat to my Ideal boiler but I'm a little confused at this point and keen to try and get some help if possible? So, when I moved in our thermostat is an Ideal digital thermostat and we've now decided to change it to a Hive system...