RickH's latest activity
-
RI have a male boss ..... M16x1 I need to connect it to a female 3/8" BSP fitting. Any of you aware of a suitable adapter - or easiest...
-
RRickH replied to the thread Thread identification.I have a Moore & Wright thread pitch gauge, and it gives 25 tpi as perfect fit, 26 tpi would also just about fit. It’s not 24 tpi based...
-
R(Previously would have gone to a usenet group for this via a Newsreader, but no longer know how to access them for free) I need to...
-
RRickH replied to the thread Planning Q.Thanks for the comments on balance. Will consider kitchen on 1 ph, cooker on its own feed on another …. On generation, not quite the...
-
RFor a new build … I will request a 3ph supply. 3ph is only required in the garage for some machines & a Solar inverter. Can/should you...
-
RRickH replied to the thread SPD Question.This guy did not have seals to do reseal .... it must also be a process thing, as next day after install, National Grid contacted me by...
-
RRickH replied to the thread SPD Question.I corrected Typo. (was wrong) The guy who installed the Smart Meter said he used to be an Electrician, but now just does contract meter...
-
RI have never used an SPD … so new to me. I know if you install an external EV charger, you should feed via an SPD. Question is would it...
-
RRickH replied to the thread Water joint leak.It's a standard 10" filter. I'll remove filter and see if it seals without one installed.
-
RHave an under sink water filter - previously annual change of filter been simple. This year it leaks slightly Filter is as per attached...
-
-
RRickH replied to the thread Brick Lights (part 2).The mortar was a pre-coloured pit sand, I mixed some up for a job last year … way way darker than stuff already used. Colour faded due...
-
RI had built walls leaving bricks ‘out’ where I wanted brick lights. I had originally purchased cast aluminium lights … but they...
-
-
RRickH replied to the thread Honda 4 Stroke.Thanks .. but I have E5 to hand so I use that .... it's no hardship tilting machine to empty tank, and then run to dry. I have no issue...
-
RRickH replied to the thread Honda 4 Stroke.It is the GX25 engine, No the carburettor has priming bulb on the right side, but I don't know the make of it. Bulb is as picture in...
-
-
RRickH replied to the thread Honda 4 Stroke.I’ll try that suggestion. On my bench tonight, oil change, grease gearbox, cleaned air filter and spark arester.
