Recent content by rivergo1d

Does anyone have any views on the likely life of this flat roof? The top black layer is cracking flaking away in places near the edge of the roof, leaving a smooth-ish but weak feeling grey layer which I'm not familiar with. We're not looking to stay more than 3 or 4 years, so would prefer to...

So the pcb was replaced but the fault persists.... No audible spark clicking.

Hi First off, I'm not a RGI, just a homeowner, and I have a return visit booked with Baxi for after the weekend, so I'm not attempting a DIY repair. But because the problem is intermittent and the first visit did not solve the problem, I'd appreciate any advice from those with experience so that...

Not chosen yet, but probably vaillant. It won't be a baxi or a potterton.

That's a good idea doggit, there may just be enough room though it starts getting a little close to the master bedroom window for comfort, despite meeting regulations. I guess the other question is when does the 2m rule kick in? I think what I read says when below. ... so if alongside...

Thanks doggit, appreciated. That was my fear, that both would apply. The windows are very closer to the edge of the roof, and I'm beginning to think it won't be possible. Picture below, the flue would emerge slightly down and left of the light (light would have to go, obviously). I...

Hi I've taken a good look at the clearance diagrams, and see clearances of 2m quoted for vertical flues below windows on the same pitched roof, or 600mm clearance around a windrow. But my situation is not explicitly covered. I would like the flue to come out horizontally through the single...

OK, I was looking for some kind of damping that assisted with that. I've seen shop floor wardrobes which do that

Thanks, how do I keep them in position?

I'm looking to install a 3 door sliding wardrobe, and have a couple of questions. Firstly, can tracks be a butted together easily to fork a longer length, or does flex in the track mean doors can stick a little as they move over the joins? Secondly, is there any way of encouraging...

Certainly it didn't sound for MY Veritas R8. But if you want a trial run before you commit by disconnecting the keypad, then perhaps simply removing the control panel lid, not keying in the code, and letting the tamper alarm sound for THAT for a few minutes will reassure you that only the...

No, the alarm bellbox does not sound if you the alarm is not armed. The only thing that sounds is the internal buzzer.

Hi, from what I remember, if you switch the alarm off and disconnect the keypad wires, the "tamper" alert will sound constantly - but this will not result in the outside bell sounding. So the only thing you need to do is stop the tamper from sounding by removing that fuse (and if you don't...

Please ignore, removing and refitting the keypad and reentering my pin twice cleared the tamper. All good now and thanks so much for your help and advice!

Thanks you're absolutely right of course, I realised my mistake soon after posting. Have now moved it and refitted, but the red tamper light is stuck on and I can't set the alarm. I've had the control box lid off before, triggering a tamper alarm which I was able to reset with my user code...