Recent content by rmt

the wall is approx 2 feet thick, large ish stone either side rendered with smaller coble infill

Hi I intend to fit an extending canopy to an outside wall of my house but it is a very old wall of uneven stone and I assume lime render, it is almost imposable to drill & plug a secure fixing, is there a type of filler which can be used and if so what is the procedure? thanks rmt

heres my answer, boiler was serviced and problem pointed out to the engineer when he left it was ok a few hours later same fault occured he was due to return to replace a leaking feed pipe, he looked at the boiler again but couldnt find the fault, I do not use this site for a "wind up" just...

I have not blamed anybody, I do not lie as you have insinuated, and there was no "obvious" diy job, I just asked a simple question.

if you give sarcism youve got to expect to recieve it, nothing to do with common sense.

thank you for all your comments, some helpful some not. I have fixed the problem, Now all I have to do is find out why the bathroom floor is always wet after a shower and solve the problem of why my face always goes red when using the microwave? GET MY DRIFT

thanks. I will try another GORGI registered engineer that will make it three, I wonder how many I will have to try before I find one with enough "savvy" to fix this simple fault

thanks for your constuctive comments youve been a great help in letting me know there is something wrong. perhaps someone can tell me WHAT is wrong

yes its the only way it will run?

Hi thanks for your reply, sorry I should have been more speclfic. he was a corgi registered engineer. ATB Mike t

Hi Recently the only way my Worcester 280 RSF will ignite is with the combustion chamber panel slightly loose allowing air in, have had it serviced but the plumber unable to solve the problem checked flue etc and all aparently ok ATB Mike t

thanks to all, I will give it a go! ATB MT

Hi The vessel has a mounting bracket which is bolted to the chassis, if the fitting at the rear of vessel is a push fit with sealing "o" ring does it just pull out? MT

Hi thanks for the reply, how do I get at the connection on the rear of vessel? seems impossible to get at it from the front.

Hi my expansion vessel has gone on a Worcester 280 rsf, has anyone changed one? have I got to take the boiler off the wall to get at it? ATB MT