RobTi's latest activity

Thanks I had the engineer out the week before as my controller was playing up and he swapped the cables out and said to connect to the...

Thanks tried that always select riser rail and yet this defaults to overhead, will phone them next week

Hi I just fitted a dual remote to my quartz digital and it keeps selecting the overhead outlet but I have set up the riser rail on...

Well just to update engineer came out and found the condensate was blocked where it was connected to sink waste, turned out the original...

The traps in the Ideal are syphon traps - i.e. they get to a certain level then release the trap contents, rather than a water seal trap...

Trap held under tap and constant flow out of it, tried around 1/2 pint of water down the condensate and runs away, actually thought a...

But now no leak after using lsx but trap filling up into sump and getting a soft thump when boiler fires, also around 1/4 l of water out...

Well just to update engineer book for tomorrow, I used lsx to seal the gasket and this was fine for a few days but getting the f2 fault...

Thanks I was actually thinking of lsx for the gasket on the access panel, but this was interesting

Thanks time to call an engineer then

Update water coming from this panel, condensate pipe clear, trap half full on outlet 3/4 full on inlet , I took the panel off and...

Pressure wise I have just noticed it’s increasing very slightly, so today disconnected the filling loop to rule that out, and will...

i know the law, but having had my ticket for around 20 years and a technician grade plumber i like to think i am a bit more careful than...

Hi I have an esp1 and noticed water leak from bottom of the case so cleaned condensate trap and double checked the connections in and...