ronniecabers's latest activity

You'll need to knock the all 3 hinge pins out, it may have a small grub screw holding it in, and remove the door sash ( much easier...

That one in your link should be absolutely fine

i'm concerned they tell you the guarantee is independent ...if they are mentioning the 10yr if they go bust , then that is an Insurance...

Well just bear in mind they are actually Everest 2020 now , as Everest went bust in 2020! ' we are nationwide ' ---- yeah and ...

NOw you have the barrel out , I'd be checking how well it works turning the key, this will tell you if its the barrell are the...

Ali bifold will create the biggest opening , sliders will only give less than 50% of the total opening. As has been mentioned spares...

are you sure the e gasket needs to come out? i wouldn't normally exepct an e gasket to be removed , as you'd never get the ' arrow '...

The door sash not closing properly sounds like it's not quite square in the.opening..twisted slightly across the horizontal or vertical...

The door hinges is normal , its where they have been adjusted ( However I am surprised to see that much adjustment on new doors ...

I'm.worried about cracks in the glass on either side...should be toughened or laminate glass. Laminate will crack , toughened will shatter

a upvc door combo like that is never going to be as rigid as an old wooden set up, wooden uprights would be solid, probably around a 4x3...

not sure what the difference in ' opening system ' would be... can't tell from that pic. If i'm understanding you right, you are after...

it will definetly be profile specific, and thats an older type of bead. maybe ask local double glazing firms if they have any left from...

I do wonder if they are fitted the right way round , and that gasket would normally be internal? I'll search my desk drawers and see if...

yeah , i'm not so sure that that gasket should be sat like that either... normally its slightly back in so water passes straight over it...