Recent content by rooney1000

So after some advice on here I managed to replace my salamander ct50 shower pump. That's the good news! However... One of the inlet 15mm pushfit connectors (hot) is awkward to connect as the supplied connectors that come with it have a 90 twist where the pipe fits onto the pump (not the...

Couple of new pictures attached - I notice that there are connections of the two vertical pipes, just half way up. I also note that this pump does all my water upstairs. When I isolate the pump I cant use the hand basin either !

I dont have a picture, can take one tonight. Interesting re the 4 connections. From memory last night I have the one that is leaking, one replica of that the other side which I think is the hot and then the two sprouting out above but not directly connected. Cant be sure so just my...

Excuse my ignorance here, DIY aint my strong point, but by isolate do you mean just turn the screw to close the valve where the water enters the pump ? I did do that last night and it stopped the water and allowed me to take off the white flexihose and re-attach (tighter). Will have another...

Hoping that someone can help and offer me a little bit of advice. I discoved last night that my salemander shower pump has sprung a leak. Have attached a photo (marked 1) of where the leak is to show the exact location as not easy for me to describe (although funny enough there was also a...

Plumbing - shower pump