Recent content by royc75

They don't have it

Thanks. I submitted a form with the picture

Hi I need to replace this valve which is leaking in our shower (last tap on the left in the second picture) Been searching online but couldn't find a similar one. Any help would be much appreciated. Thanks in advance

Thanks again @sparkymarka something tells me you've got experience with this particular alarm :)

Found it in the manual.

By the way, how do I now change the engineer code from its default ?

It worked with option 38. @sparkymarka Thank you so much for your support, much appreciated

Think I’ve managed now I’m in installer mode with the default code ! How do I apply the temper changes and exit tjis mode ?

I tried the procedure today, it doesn’t work. I tried keeping two screwdrivers on both pins pairs. Any chance I need to use something else to short circuit them ?

Here’s a picture of the board if it helps. The fuse box is next to it, not in the picture

Thanks for the walkthrough. It also has dedicated mains power switch in the electricity switchboard, do I not need to bring it down as well (step 1 in the manual) ?

I tried the default one yes, doesn't work, and the company who holds it wants 210£ to have it removed, not giving them that pleasure. The control panel has a fuse box next to it which I believe is alarm related but then again I'm no expert. Is that important to the procedure above ?

And another question please: I don't suppose there's a way to supress this tempered warning and restore the alarm without the engineering code right ?

Ah right, thanks :) But step 7 says remove it. Am I suppose to keep two screwdriver blades on both of those pins and reconnect the battery afterwards and only then remove them. Sounds like a two person job. Also, are you sure it will only reset those passcodes and not the entire setup ? Have...

Thank you, I think I have that manual too :) When you say "Do a stage 1 reset" do you mean steps 1-10 in first stage reset chapter ? I know how to do steps 1-3, no clue how to do 4 onwards :-/ How do you short circuit those pins ?