Recent content by salroc48

Thanks Sleepyhead for getting back to me, how do I locate a new module and where do I find the correct one? on the plastic PCB cover is CBMFD 220-240v CB-PM-FD, also WK0316 (and a large Number in Bold) 505 Do you know where i can buy a module as I cant find anything with my machine model...

Still the same problem -- I've changed the heater and the NTC feeler but with no luck, the dishwasher goes through part cycle then bleeps, when the door is opened the start light flashes three times(what does this mean?) i've tried this on all three settings with the same results could there be...

Thanks Sleepyhead, I've ordered a NTC feeler ( getting to know your lingo ! ) so i'll give it a go and let you know the result.... thanks for your prompt help.

Thanks Sleepyhead, The PCB is clean and not dammaged at all, do you know if there is any way of testing the the NTC Feeler before I buy one. thanks for all your help. :D

Just gone through its cycle again but the 3xflashes are still there and no heat.. Any ideas please.

Hi I have replaced the Tubular heater, the 3 flashes have stopped but there is still no hot water during the cycle.. is ther any thing else I could try. thanks PS The heater was faulty so did need replacing..

thanks Sleepyhead, I'll give it a go.

thanks S, where is the heater located and is it easy to replace? Ive seen the lead to the NTC but unsure how to test it. any ideas please.

Hi, could you give me any advise on the 3 flashes on the light of my dishwasher, the water does not get hot and the program is not completing it's cycle, can you help?

Thanks, Tiredengineer & Nigeld, Circuit board was the cause, washer now repaired and working OK. you've saved me some cash as her in doors wanted a new machine.thanks again.....££££££££

Hi, hotpoint wont start, I've changed the door switch and checked for power, But machine still not kicking into life ! Any ideas please??