Have fitted the attached pop up waste.
The rod is connected. I can get the waste to seal with the lever. But when I try and drain the water, it does not rise high enough to let the water flow out quickly. It will let the water out at a very slow rate. I can use my fingers to raise the plug but...
Hi all
Looking for some advice.
Took this radiator off for decoration and flushing. Have put it on the nut in the pic leaks slightly can’t seem to get the not to the right level to prevent the leaking . Any advice or should I just loosen and try again.
Thanks.
Btw it is the nut on the right...
The front door lock is a little temperamental. It locks and unlocks very easily from inside the house. When locking and unlocking from the outside it is much more difficult and feels as if the key might break.
See pics.
Any advice please. Thanks.
Will wd40 help or not. ?
Have not tried it...
Hello
had an amtico floor fitted over a year ago in the hall downstairs.
Starting to see these marks on the skirting board. Don’t think it is a radiator leak. Any thoughts. See pic.
Thanks
Moved house.
Front door lock picture is attached.
It is a little temperamental
Have 2 keys sometimes they lock sometimes they don’t. Any advice on freeing the lock for smooth and guaranteed operation
Is there something I can squirt in. ???
Thanks. In advance
Got a diamond Bidex 500 under the cooker heater plinth heater. Does not seem to give any heat out when switched on.
Thanks in advance.
Btw central heating is working fine.
I have a medium sized bedroom
there is only one double socket on a wall in the room.
Basically I need another socket on the other side of the room.
I would prefer not to have an extension socket with trailing wires or to damage the decoration by installing another socket.
Any other options...
hello
I have a utility area with 22mm central heating pipes going into the kitchen from the garage ( where the boiler is ). The pipes go from the garage horizontally and above door height through the utility area through another wall into the kitchen. Problem is the utility area is cold ( no...
Spare bedroom has been replastered. Plasterer took the brackets off. Pipework is fine. Any advice how I put the brackets on the wall at the correct height to match the pipework with the radiator. Thanks in advance.