I have a westhern trv which i was attempting to mend by shaking the pin up and down as the valve had become stuck. I accidentally pulled the pin out.
What's the proceure for re-fitting it?
i don't know what a freeze is. i thought it might involve draining it down. Is there any good resources online on how to do this?
i think the manufacturer had a west in it.
not sure, although i could check.
it did dribble a bit but i put the pin in just to make a crude seal.
it seems fine with the central heating on, although obviously it's running at full heat, which makes for an extremely toasty bathroom.
is it possible to fit it back in or will it have to...
upon finding out how to fix a cold radiator by loosening the pins i became slightly over-zealous. While moving the pin in and out to loosen it up i accidentally pulled too hard and the entire pin has come out.
I put the pin back in but it won't go in all the way, how do i go about refitting it?