Recent content by scazz33

At Madrab if you looked at my post you see that vessel is in completely different place to the boiler and ITS NOT internal, that means it's not inside the boiler.

Now my boiler keeps going off, it lights stays on for a minute and goes off and also the pressure keeps dropping.

Hi guys My old flexcon 8L 0.5 gas charge from 1998 was so heavy it was full of water now I don't know if that's faulty or not, I now brought a new zilmet 8L 1.5L My old one was flexcon 8L 0.5 gas charge now my new one is zilmet 8L 1.5. Is this going to be ok or not as now my boiler won't stay...

Cheers guys. I've brought a expansion vessel and says pre charged at 1.5. On the guage in airing cupboard the red plastic line on the outer side of gauge reads 1.0, but when the system kept rising up above pressure 1 bar upto over 3 bar the valve downstairs by boiler let water out down my...

After I replaced the filling loop and mid position valve. The red expansion vessel was so heavy I undone the nut and was full of water, I empty out in bath and it was black water and smelt bad. Is this correct

My old 3 way position valve was a ACL 22mm and it got replaced with new shiny silver one with metal lever. I took photo of the old acl wiring and also written it down on piece paper the wiring. The new valve had the same colour wiring and so I copied it like for like. Now the new one makes a...

I swapped over the filling loop new valve. Where do u put the inhibitor. Thought was loft tank, but my system fills up from mains I think

Hi guys. I'm having problems with pressure keep going up and prv letting water pour out down my outside garden wall and looks a mess and also I think the 3 way mid position valve is stuck as when water comes in the heating does to. I have brought a brand new filling loop and new 3 way mid...

Hi guys Is a central heating filling loop and 3 way mid position valve hard to do yourself, they both located in upstairs airing cupboard. I got water flowing down the back wall and looks green and the valve is stuck between W and M and water and heating both always coming on together...

Can a filling loop be changed yourself are they easy to do. Has the central heating system got to be drained to replace the filling loop?. Thanks guys

Hi guys. The pressure is still rising up to over 3bar. The red vessel now feels very heavy. The mid position valve keeps getting stuck it's motorised but doesn't move u have to now manually move it, it has w, m ,h but it seems only it move to middle manually. Also the water is taking forever...

Thanks didn't know if the water went left thru the silver pipe from the metal pipe or right and stop before the metal down pipe, if that makes sense Are the filling loop and vessel easy to change yourself or is it gas safe engineer job.

Can u explain please, I'm not no plumber your very experienced or a plumber. I don't want to get a soaking

The filler tap, this bit

Yeah it's in the middle, turn it left to fill it and right it's off. This pic below is 17.15pm when I switched water on.