Recent content by scoobyblue

yeah you are all pervs. Now help me with me stack..

perv . hahaha

I am considering removing the chimney breast from bedroom and diningroom.It is 1 breast that is at the rear of my house and i want to remove it to loft level.I cant take it to roof level as i still need the chimney breast at the front of the house for the livingroom gas fire.It is on a party...

did as above . cleaned out h/e (until i can afford a new one) with pressure washer,checked expansion vessel (low - no air) recharged.Refitted h/e ,repressurised, nice hot water again. VERY BIG thanks to nogoodatfaultfinding.

when the boiler is cold can i close off the heating flow and return valves and drain the boiler from the boiler drain point (not relief valve) and check the pressure in the expansion vessel?

Turned on the nearest tap to boiler just enough for it to fire ,water got hot but the flow reduced to a trickle. I also noticed the pressure gauge increased and there was a rushing water sound coming from the boiler.Turned off tap and pressure gauge dropped. There has been gas works in the...

If i just fit a new one wont it just block up again.I thought if i add a sludge remover and drain it would help solve the blockage problem.Would fitting a Magnaclean afterwards help?

could i add a sludge remover to the heating circuit to clean the plate heat exchanger then drain down and add an inhibitor or do i have to remove and clean?

no matter where the hot water control is the temp leds light up right up to 80 degrees.

I have a baxi 80e combi about 7 years old.The heating works fine but hot water not.When i turn on the h/w tap it runs hot then cold,hot then cold . The burner activates for about 20-30 secs then goes out,it does not modulate.The diverter valve was checked and seams to be operating as it...