Recent content by scorpiouk

Hi, So installed the ProSound, all went well.. Only 1 issue. The squark when arming is unbelievably loud! Checked in the manual, it says the volume can be adjusted between 0 and 9 Menu 8 - 3 - 1 * 0 - 6 Except on my system 0 -6 is missing.. I thought firmware differences between the manual...

callout charges, :( all willing to sell me a new system.. Just need an hour of good weather to get this battery in and can then test the new bell

I will try what you have suggested just need to get the system back first. Investment in a new SAB seems worth it.. Had 2 Alarm engineers in the past, relived me of money and still left issues.. Patience and Google :)

Just an update on this. The weather at the weekend was not great so wasn’t up for any diagnosis of faults. I have purchased a ProSound as this used a bus interface. Bit simpler to see what’s going on. It’s installed, panel sees it as bus device, so the comms looks good. Just need to install...

I will try recreate the issue at the weekend.. I don't remember changing anything.. But I must have caught something and saved it without realising.. Where can i check the normally closed or normally open setup? "was the bell initially triggered for a very short period?" - Yes, window cleaner...

Hi.. The logs are not much help... Its full of messages about DHCP and unable to see the internet. I cant get the IP module to reach the internet on a Draytek router.. Works fine if I go back to the old BT one.. As it only keeps 500 entries there is nothing we can use.. When the problem...

Hi thanks for the reply.. The alarm is set as follows: [

Hi, I post here a few years ago about connecting a nova guard sounder to my alarm system. It’s been working well for years. Believe it uses UO for activating the sounder. (as follows) Diagram: Nova: Lightsys: Bell Trigger S- U01 NO Strobe Trigger STR-...

Thought id give an update.. So after a lot of work I have tracked down the issue to the way DHCP is issued by the Draytek router.. Using the BT router is fine.. Looking on the alarm, and the router there are errors on both.. Strange, both ping, so not sure what i can do now... Will look at it...

Hi, Just an update on this.. So ran a 50m Ethernet lead around the house bypassing the internal stuff. Checked the logs and could see the Alarm (192.168.1.37) reaching out to www.riscocloud.com. Much better! Have had the internal cable re-pulled, and we just ran out of time to terminate the...

Call home I mean, the alarm must register its self to the cloud via the defaults. But how often will it do that. Just constantly try or is there some trigger needed. What’s CS? And how do I enable it? Least then I can disprove any LAn network issues.

Thanks.. do you know anything regards: Should I be able to login to the panel locally via ip? When does the panel attempt to "call home" ?

Thanks for the reply.. Should I be able to login to the panel locally via ip? When does the panel attempt to "call home" ? Will PM you once all the LAN etc is check

Hi guys. hope someone can point me in the right direction. I have a working lightsys with a GSM module, its been working great. Set / unset + alerts at activation etc have all worked well.:) Recently added an IP module.. Connected it to the network. I can see its mac address connected to the...

CU is about 10cm from will trace it back