Recent content by scotsman

F05 means your pump is blocked.

Your power module is probably blown.

Check pcb behind contol panel for blown tracks.

Check pump for blockage.

Unplug the appliance and check the main pcb behind the control panel has not got any burnt tracks.

It is what holds the lower wash arm in place (you do not need to remove the filter). it is in the centre of the appliance.

Drop your drain hose into a basin on the floor and see if you get any water out. If nothing comes out you have to remove the backplate and clear the blockage from your sump. If the water comes out you have to remove the hoses from the pump and check it for blockages.

The anti flood device is a piece of foam in the base that rises when there is water in the base and closes a microswitch connected. The only way to reset it is by tipping it and thus draining the base. Check if your lower arm is loose by removing the lower wash basket and tightening the...

What happens when you get water in base is that id doesn't fill and will only drain. To remedy this you have to tip it backwards to drain the base and reset the anti flood device. The main cause for this is the lower wash arm fixtures works it's way loose and drips into the base.

water in base. pull out and tip backwards. check lower wash arm is tight into base.

Your stat will be open circuit.

Check your heater is not open circuit.

you do not need to change the stats every time. on certain models you can reset them by pushing a needle down the centre hole till you hear a click.

Remove top and check top weight is not loose, common fault on this appliance.

Remove top, control panel and you will probably find pcb has blown tracks on it.