Recent content by Scott Fairley

Hi mate the gate valve l have turned this off when it's open full the amount of water went all the way up and it was around an inch from coming over the top of the tank, I started with changing the taps in the bathroom so l turned the water off at the mains l the turned the gate valve to close...

Only one bathroom mixer tap for the bath but before l connected the tap l put 2 normal taps on the basin and trid the water running through the the cold was ok but no water out of the basin tap l didn't contact the mixer at this point

Also if that works and l still have no water from the hot tap these tanks are crap for pressure would you recommend a new tank that can hold pressure?

Ok yes it's back filling if l put a valve on it will that stop the water from going from the cold down the hot tap? is that why when l turn on my gate value it's filling the tank up and not stopping.

Hi yes the gate valve was turned off the top part of the tank seem to be working with the ballvalve but it's the gate valve the water seem to be just filling the tank up and not stopping

Hi just looking for some advice, l have a fortic cylinder tank with the cold water tank attached above one unit, l replace my taps in the bathroom bath and basen l turned the water off on th he tank and l have an isolated valve to turn the water of for the bathroom supply, l have come to turn on...

Hi guys l have the same problem, change my taps in the bathroom and now no water coming out of the hot water taps, l though it maybe an airblock so l contact a flexi to the cold water and hot tap and turned it on to clear any air that maybe trapped, but l then checked the fortic cylinder tank...