Recent content by sean ryan

Fitted new repair kit all it good the old diaphragm had a hole in it

Thank you all very much for your help

Your a genius pin did not retract when turning cold tap off when pushing pin back yes I have heating so if I buy a diverter valve repair kit that will do the job

I believe the pipe works all under laminate floors here's a pic of the pin it's slightly out but not reaching the micro switch and the valves were ok

Ok thanks will check all when I get home later and hot water is fine

Both the sensors have been changed here is a video taken from cold https://youtube.com/shorts/_RV1SPlP0Gw

Done it re fitted same result it sounds like the pump is running all the time

Cleaned the filter out still the same

I'll give it a go another boiler drain down

Just fitted new Ntc still the same

Will do thanks

It does not move from 80

Pm me you email address I'll send it I can't post it up here

Took it off cleaned it all up prodded the hole put all back together same thing is still happening