Recent content by Seaside99

Hello, I'm currently redoing my bathroom and im about to fit some replacement gypsum plaster coving and I've patch filled various areas on the walls to try and get a nice finish when I paint the walls. What should I use to prime the coving? And should I prime the walls first to reduce the...

Thanks for your help, much appreciated.

After the Gardz has fully dried would I need to PVA before I plaster to help with adhesion? Or just plaster straight on to the gardz? Thanks.

Hello, I recently removed an inbuilt cupboard in the bathroom. The lenght of the wall it was on, is now going to have bathroom panels installed. I had to install a new piece of plasterboard from floor to ceiling and about 80cm wide (which would have been the inside of the old cupboard). I've...

Hello, I've removed a piece of coving (as shown below) as it was left a mess from removing a builtin cupboard. I've also now decided to remove the rest of the coving in the room as that is in a poor state. I used a multitool to carefully remove the coving, especially around the artex which then...

I placed a piece of paper just against the curve and its measured around 116mm. The back of the board says it is made by Gyproc. Does the 127mm also include the top and bottom edges of the coving which must be around 5mm each. Would 127mm Gyproc coving from B&Q match up?. Thanks.

Many thanks for the advice, I will give that method of measuring a try, cheers.

Hello, I need to replace a piece of existing coving. I assumed it would be standard 127mm coving but I measured the existing coving in place and the drop is approx 82mm but the projection from the wall is around 90mm. From what I understand 127mm coving should be 83mm for both measurements...

Hello, My Rameha Avanta Plus 24C Combi boiler needs replacing and I have been quoted for a Worcester Bosch 4000 30kW. We use two LPG gas bottles and we live in a small 2 bed house with three radiators (which we only use about twice a year, due to having a woodburner) and one bathroom. I did...

Hello, I have a Remeha Avanta Plus 24c boiler (11 years old) which runs from two LPG bottles. We started getting an intermittent E5 error about a month ago, which tends to disappear for a bit after a couple of restarts. I assumed it was a faulty LPG regulator as this had caused the same issue a...