Recent content by Seftonm

One again thank you for your assistance.

Dear sparky I am glad to let you know that the problem was in the cat five cables. After having obtained a meter i made a continuity test of all the cables going to the bell and found that four out of the eight wires were not completing the circuit. Having said that this is not a surprise since...

Tried to short BA at panel with the negative terminal of the battery but noting happened. Tomorrow i will obtain a meter and check as you suggested. I will give you the readings. Fuses are fine. Once again thanks for your assistance.

Shorted BA to S- in the panel but no sound from the bell. Even replaced the wires to eliminate any chance of a broken wire Wiring issues is highly improbable. Could it be i’ve fried a component or two in the pcb when i was disassembling the sounder as i did not power off the main unit while...

There is no B- on the panel as indicated on the wiring diagram above. The wire at the sounder B- is connected to S- in the panel.

Checked the wires for continuity. Everything seems fine. I guess the problem is something else.

Hi again Below to this post i’ve attached the wiring diagram of the main panel to the bell. What i did is i shorted BA to S- in the main panel and the sounder did not go of. I think that this should sound the bell as these are the same wires at the bell. Does this mean that i have a broken...

Sorry but i do not understand. Should i bypass b- and ba at the panel?

This is what it looks like

Yes i’ve plugged the sounder on the bell back on.

I’ve bypassed b- with ba as you suggested and the sounder does work. I did not disconnect any wires from the panel so wiring problem fro the panel side is impossible. I’Ave cheched and rechecked the wires on the sounder and everything is as was previously. Can you tell me which wire signals the...

Yes i’ve tried the panic mode but same the main panel goes of but not the bell. Will try to bypass b- and ba and let you know.

Yes the panel activates when i remove the bell cover and the temper led switches on.

1. Yes when i open the bell it rings. 2. The bell is located outside on the balcony. 3. As far as i am aware of the panels has no relays 4. I did not remove any wires from the panel only the wires on the bell for disassembly. Below is a photo of the panel

And this is how it was connected before i took the bell apart.