Recent content by sensible

After following the instructions above I got the readings from my multi metre. I went on ShowerDoc.com and posted a question in relation to the readings and how easy/difficult it would be to change the heat tank. I recieved a speedy reply confirming the heat tank was faulty and that it was not...

I have found the part number for a new heat can assembly P12120706 (for 10.5 KW) which the cheapest is about £39 inc postage. Is this the only part I would need or are there any seals etc required. I would welcome any advice.. thanks

Firstly I unscrewed the cover and switched the shower between cold, red1 and red2. I was able to see the switches on the PCB flicking across, so presume that all is well on the PCB. I then followed the instructions and firstly noticed that my multi metre loads of ohms settings, so set it to...

Thanks... I will check it out tomorrow and post back here.

I have a 3 year old Triton Opal II (10Kw) and was having problems with a low pressure light. I changed the PCB and it seemed to solve all my problems and was working perfectly for a couple of weeks. Now I notice that it isn't as hot as it should be on high setting. It doesn't matter if on...

I have had an ongoing problem with a low pressure light coming on. I tried the fix with a bit of card under the micro switch and this worked for about a year. Recently the low pressure light was coming on when using heated water position 1, but was okay on heated position 2. Then it started...

We had a new kitchen fitted last week and had a Neff U1722 double oven fitted. This was not cheap at £760. Since it was fitted it makes a vibrating noise, normally when the thrmostat cuts in, when the oven is hot enough. Went back to the store to get it replaced and they insisted we had the...