Recent content by shead

  1. S

    under sink water heater!

    yea its under 15 litres..no seperate vessle. sounds rite enough tho 'ICGS' yea.there is only bout half a meter between mains coming in and blow off. dont have much room to change that tho! would reducing the preasure cure it because there is an isolating valve on mains. No its not a faulty blow...
  2. S

    New Wet Room Install

    You just want people to admire your work! :lol:
  3. S

    under sink water heater!

    I have an under sink water heater.....problem is its cosntanly blowing off water out the blow off valve. its an "Atlantic " water heater. i turned the heater off for 2 days and its still letting water out every 5 minutes or so. very strange as i know the blow off is used to allow for expansion...
  4. S

    mixer shower problem!! no cold coming through!

    shower has been working fine for years....problem is, cold water has stopped mixing when shower head is in its holster....but when i bring the shower head and hose below the the outlet on the shower valve the cold mixes through then.hot and cold valves are on as usual. any suggestions...
  5. S

    coil not heating on hot water cylinder

    opened with resistance yea but pipes did not warm up. i held it open for bout a minute. maby i should keep it open longer???? if so why is it not opening automaticaly? replace? thanks for reply. thanks bolton...ill try that if this dont work.
  6. S

    coil not heating on hot water cylinder

    Hey people, Central heating working fine but the coil on cylinder not heating properly. the return pipe is warm but the flow pipe is cold so not getting any hot water at all,wel sometimes a little bit warm but only or a minute even if the boiler on a couple of hours. there is no air in the...
  7. S

    reset button on control box needs pressed 1st every day

    100% John thanks very much...ill get that done and let you know the result sure...much appreciated. :P
  8. S

    reset button on control box needs pressed 1st every day

    Thanks for replying John. i serviced it just last year but i suppose there would be no harm doing it now again after this winter we're having. could run a bit smoother alright.would the solenoid valve be at fault at all? thanks again. :D
  9. S

    reset button on control box needs pressed 1st every day

    hello...I have a bentone oil burner. its 6 - 7 years old. problem is, when i turn the heating on first thing in the morning nothing happens until i go out and press the reset button on the control box, everything works fine after this. ive changed the thermostat and the control box but nothings...
Back
Top