Recent content by sheff1

Genius! so simple and like a pillock I didn't try it Many thanks now to see if the hot water works Thanks again

The blue tap is vertical. But there is no flow from anywhere on the hot taps. Is there a safety stop somewhere?

oop's gone behind upstairs shower unit and turned off water supply to hot tap. NOW even after I have turned it back on. NO water from any hot taps either upstairs or downstairs! blue knob in correct position and I am clueless. Roll on monday

cant see it crossing over anywhere! upstairs is a couple of mixer taps but they dont run through the hot tap when the blue inlet is turned off. It was all ok before this leak and all I have done is connect a stop tap and connect the pipes back together :? Honest! thanks for trying

not got a clue! was working ok before the leak. crossover wont be on mixer taps as water only exits there? turned off pipes to washer. and only cold feed to dishwasher. H.E gets hot, as do pipes in the boiler, but not DHW pipe from the boiler. I think indicating a blockage? (ok im not a...

Still flowing and cold, with hot and cold turned off(isolating the washer)?

just double checked! The hot pipe is straight to the kitchen sink with a T junction off to the washer. this is how it was before. and it is where the leak was from originally. I haven't done anything different except put a stop tap there incase it happens again now im getting worried cos i...

Turned off blue water inlet knob and upstairs the water stopped flowing from the hot taps. but it still flows fast from the kitchen sink. does this mean anything?

Thanks Tony, Yes it is a black sensor (your good and you know it) I did place a magnet at it's side and the water was heating but before it could come through hot, the temp exceeded 65 and it cut out. Will get the yellow pages out now. Thanks again

hi, Thanks for helping. The red light is not working on the magnetic dhw flow switch, but shows red when I place a magnet next to it, biasi says it could be the DHW heat exchanger that needs flushing? would I be better off just removing and cleaning the flow switch sensor parts or is it a really...

Hi, I have a biasi garda he, and after a leak we only have C.h all lights are working but no D H W any ideas please thanks