Recent content by shepsamiller

nope cant hide cables there,the lights are located in the dining area of kitchen,but thanx for advice.

hi everyone,i,m wanting some advice on having downlights installed when i have my new kitchen installed but have a problem. i,m wanting to add 6 240v downlights.The problem i have is access to run the wires, above the kitchen cieling is the bathroom,which has a tiled floor so no access available...

i,ve known the thermostat contacts fuse together after a fault with the element,i would say its down to a current surge from the previous fault,,,thats why your preheating light is always on new stat required mate,a mulimeter would comfirm this,,,,,,[/list]

If its the mcb tripping then you have a short circuit(current overload) if its the rcd then its earth leakage, isolate circuit and disconnect element, find the wattage rating of the element for example 3kw divide this figure by 230 will give you the amp draw in this example 13 amps then divide...

do you have a multimeter for testing,if yes i can talk you through it.

nooooo,, the total load of both the oven and hob cannot be supplied off one 6mm cable, i,m afraid youll need to upgrade the supply cable,ideally 2 seperate circuits are required from the c.u. with the adequate protction.[/list]

hi dom,your antiflood is active,Unplug the appliance,, to reset place a large towel behind the appliance and tilt the appliance back as far as you can allowing any water in the base to flow out onto your towel..Then press the reset on yout timer,,select a programme and now all should be ok.