Recent content by Silvermoonplumber

BAHCO, best advice for this guy definitely. He could run pipes from Cold Water Cistern to cold bath taps, nothing wrong with that just a damn sight easier to but seperate taps..... :lol:

Woh, calm down. The guy did not say that it was a mixer. he stated they were TAPS plural, so what I said made sense. Pressure is not the same as static head. I know static head is affected by height (like I said 10m = 1bar pressure) A larger diameter pipe to his HOT tap (like he started off...

The only thing you would find useful to fit on the taps is an isolating valve (service valve) on each pipe which means you could then isolate each of them if you ever needed to work on the taps in the future. Pressure and flow rate have nothing in commmon. Pressure is the volume/area. For...

0.5 bar is the minimum pressure that water companies are allowed to push out anyway so i wouldn't worry about it.

Yes, sorry did actually mean your water supplier company and you do have to inform them, even on a meter. Boy will they like you!!! lots of money!! 15mm might well be alright, if the specs say it will cope...... Good luck with it. :roll:

You also need to tell water authourity you are fitting the pump, its a legal requirement due to the volume of water the pump draws. You would be better using 22mm, might be a bit time consuming now but you will sorry later if you don't....... :P