Recent content by simons38

Well I have had my circuit board changed (green led ) 2000801990 and thermistor 2000802635 but the boiler still wont light. The sequence it goes to on led is burner led flashing fast 8hz. Any ideas ? are the two compatable ? Thanks.

[b] Can anyone help. I have a Glowworm Micron 50ff , I need to replace the Thermistor. The new one i have bought has a much smaller copper probe than the original one. The serial no. for the new one is 2000802635 it says it is for a 50ff. ?

I have had the electric tested and all is ok. He wasnt sure how to set the temp on the led by the two small buttons. Anyone know how to do this please ???

thanks for that I will have to get onto the tech lads and see if they can help me locate the sensor and get a spark in too ££££ :(

thanks for the replys. The water is hot at the taps but the radiators are cold and the system doesnt respond to the room stat. I checked the heating pump and it wasnt running, turned the system to electric back up and the heating pump runs and the rads get hot. If I do this for about 20mins then...

Anyone out there know about a gledhill boilermate 2000. The property is 4 years old, about 6 months ago the heating packed up so I put it on the electric back up for about 20minutes. turned the system back to normal operation and it worked fine. Have done this loads of times but this time it...

have a look at Kamco.co.uk under power flushing, hope this helps

TRY BLEEDING THE RAD, YOU WILL HAVE TO GET YOURSELF A BLEED KEY AND AT THE TOP OF THE RAD YOU WILL SEE A SMALL SQUARE SHAPED NUT TURN THIS WITH THE KEY UNTIL YOU GET WATER OUT THEN TIGHTEN IT BACK UP AGAIN