Recent content by slinger1953

A brilliant couple of links, thank you very much, it went like a dream. And for a change, I even did it without breaking something. so, once again, thank you.

Hello, I have a five year old Vauxhall Corsa. For most of that time I have had a Phone holder clipped to the centre vent (like you do). The flap holding the clips of the phone holder has come away from the vent and the centre spine holding the other vent flaps has falling inside. I can...

Thank you both, I think that between you, you have sorted me out, thanks again.

JobAndKnock.Thank you for that info, I don't suppose you remembered the link to the manual did you? There was indeed a washer stuck in the packaging of the blade, and this did fit into the 20mm bore. so things seem to be o.k. now, although I have not replaced things yet. (the manual would be...

Hello, I bought a replacement blade, a Bosch Standard. 184mm 20/16mm 40point, for the B&D KS865KN, and was assured it would fit, I do not have the original blade to compare. I have tried to fit the blade to the Saw but it just does not seem to sit over the inner washer. can anyone advise me of...

Can anyone advise me please? Ten years ago we bought a single drainer two basin kitchen sink from B&Q, Naturally times have changed, but we now need two new basin plugs, B&Q do not stock the size that we require, and to tell the truth were not very helpful, after all it is 10 years...

Stainless steel; 80mm 15mm deep. pin 53mm x 8mm

Thanks very much for the tip, I'm sure that my friend will be fine after this help. Thanks again.

Thank you all for your replies, I have passed these comments on to him, on his behalf I also spoke to someone at a Honda dealership servicing dept. the guy there said "whats that?" when I mentioned Wynns stabilizing fluid. that sort of wrapped that up I think, he went on to say that the Battery...

I am sorry, I should have said that the vehicle is a 1400cc petrol engine.

My friend wanted my opinion. He has A Honda Jazz, but will need to leave it standing for a couple of months, although he will be able to turn it over every now and then. He has been advised to put Wynns Staberlizing Fluid into the engine, to assist the restart and eventual running. He asked...

bernardgreen, and everyone, thanks you for your last response, I think I can consider my original question well and truely answered, I'm very gratefull. thanks

thank you very much for the advice given, and I will have a look for RS Components, should I install these components in only the fittings that flash? and one final question, I have used energy saving lamps for a number of years, why has this suddenly come to light do you think? if you will...

thank you very much for the advice given, and I will have a look for RS Components, should I install these components in only the fittings that flash? and one final question, I have used energy saving lamps for a number of years, why has this suddenly come to light do you think? if you will...