Recent content by SlipNcut

Big all. Thanks for the welcome, and thanks for the info. Much appreciated. :D Freddie: Yes, Henley, Alcester, Warwick, all around there is "my territory." Anyhow, it's 23:58, and I must be up by 05:00, so I'm off. G'night folks! :)

Yes, indeed I am. Not very near Walsall though. Nearer to Stratford on Avon.

Thank you Freddie. See, I am a DIY newbie and deadhead, but other than in that particular field, I'm not quite so dim. I appreciate your clear advice. Walsall? I dont quite understand. What is the significance of Walsall?

Funny? No. Perish the thought my man! :o You arent funny. You are serious, experienced, accomplished, responsible, mature, dependable and highly skilled, I'm sure. But funny or helpful, you AINT. :evil:

:? :? :? Erm...... Now you come to mention it......... No, I haven't, but it would make good sense. :oops:

Thank you guys, for your answers and advice, which I will follow. :) Regarding the 185x24x20 numbers, would I be right in guessing that it refers to diameter, teeth and bore? :roll:

Thank you Freddie. Your response was about as useful as a politicians promise. Next time I post, be nice......... Stay away.

Greetings from the Midlands UK. I have to cut a number of facia boards, lengthways, removing 2cm. The approx length of each board is 60cm. I tried a circular saw, and failed to get an accurate cut. I tried a jigsaw, and broke all the blades as they kept bouncing out of the cut. I've used...