Recent content by Smileysmile

Recently water has been exiting my overflow pipe onto my garden patio. I believe the water tank in the attic is the CH tank. Can anybody from observing the attached video clip give me advice how to resolve this. The water entry you can see slight drips when the ball cock should when at its...

Yes, I've looked at some youtube videos. Just need to take my time. I have to decide whether to use alan key in drill bit or alan key by hand. I hope it tightens smoothly. What can possibly go wrong

I'm using this Rivnet tool

Speaker pods click on above

Drilling into the rear top corners of fan. When you open the tail gate looking inside van, the top corners which face inwards. I'm sure it'll be fine. Brush some rust inhibitor on the edges of the hole then pop riv in and tighten up. That should seal it. I read some where squirt some oil between...

I am not sure if I'm posting this question in the correct category. I've drilled 4 11mm holes for 4 M8 Rivnuts into the top inside rear corners of my VW transporter t6.1 to hold speaker pods. My concern is the bare metal left by the drill bit. I placed masking tape around and on the drill...

It makes sense. That pipe is in line with where the problem lies. Maybe next downfall I can examine the flow of water from that down pipe.

My elderly mum lives with my brother. His garage was converted into a room for her. For over a year during heavy rain water has seeped into the dwelling. From the top left corner of window as you'll see in attached photo's. I've checked for broken tiles, gutter is clear and resealed top of...

I've attached photos of my jet washed patio slabs that are only 5 years old. What are the markings that I can't seem to get out. I've a powerful Karcher jet wash. I've not spilt anything on them. What is the solution? The best sandstone cleaner. Thanks

3 hours without rain so far

Too late. 2 coats on. I gave 1.5 hr between coats. 17° outside and bit of wind. Just want rain to hold off.

I think I might leave it. It's prepped, ready for paint. I'll leave it until we have a dry period and if we have viewers then I'll explain and leave paint for them if they choise to buy. It looks better than before. I don't think the fact the pipe is asbestos will put them off. It's ready for...

Its me again. This paint is recoatable after 1 hr, 4 hrs to harden 7 days to fully cure! It looks like intermittent rain all week. Is their any paint that you can use in this weather?

Top man. Just ordered to pick up tomorrow. I hope rain holds off

Just checked it out. Screw fix 1L 24.99! I hope this will give it 2 coats.