I would get a proper Corgi Heating Engineer to look at it . It sounds like you are out of your depth... :D lmao
Would that not be your standard reply...
Sorry,I only hire it out if you agree to the driver aswell.
Also, I have not got a peaker, I ususally use my kango if I need to remove any concrete.
Cheers Soft
If she had been rammed up the back side she would not have got pregnant in the first place... :P
Well done Thermo, because I travel from North to South alot, I find Northerns more willing to help than people who live in the south.
I stopped to help some one with a spare wheel change in...
Gas4you is right in saying the hot water boost will not work unless the vailiant thermistor is fitted and not a cylinder stat. I used a essex boss and a solar heating fitting to fit a valiant thermistor in a normal hot water tank.
You then get all the functions, including the temp of the...
I use a dyson with the filters removed. I then put it out side and use an extension hose with a wall chaser. I does a very good job.
The room will still need a quick dust after though :lol:
Try turning down the heat output ( I think it is under d1 in the install settings ) . If it is set too high, these boilers seem not to like a large temp difference between flow and return pipes when they first start up.
Does the vrc400 have a backlight? I have just fitted one to a Ecotec 428, it all works fine but when it goes dark , I have to turn the light on to see what the display is showing.
The manual does not say anything about the backlight . Was I expecting too much to think it would have one?
There are no glow plugs on this engine. The only thing that stops it from starting from cold if it starts first turn when warm is it is not turning over fast enough. This could be a bad battery or the cables from the battery to the starter, or the starter itself. I would check the cable...