Recent content by spanner1

Make sure filter is clean and pressure chamber ,if no different could be faulty pressure switch ..but i reckon it will be a blockage some where.

Could be heater that has low insulation ,you could try and disconnect heater to rule it out.

Hi thanks for the advice. Yeah sorry should have mentioned that there are no isolating valves and no combi bolier . I was hoping that there might have been a valve, that you could buy that would just cut into the existing pipe work ,that would just cut the water off while i removed the...

I am going to replace my worktops , but wanted to know is there a way that I can isolate the hot and cold pipes under the sink without draining down the system ? I will be refitting the sink so just want to disconnect the sink to get the existing worktops out and put new in. Any think I...

That's what I am gonna do now and order from TLC. All the best to you.

I agree about the 2.5mm cable that's why i went for the 4mm instead because of my 32amp rating.It is dearer to use as i could just put T&E instead, but wanted to go roughly with the manufactures flexible cable in-case i ever need it fixing and the engineer comes and says i should not have...

Thank you that's all I wanted to know . All the best to you.

Thanks for looking but this does not answer my question about using the 4mm heat resistant cable i first mentioned.The manual specify that a 25amp monophase for protection for the oven .The hob does not specify what fuse rating should be but they said ho5rrf-3g 2.5mm cable. Why do people...

Hi first post so go easy on me guys/gals :) Would like a little advice on fitting a hob and double electric built under oven. I have seen an electric ceramic hob which is 6,700kw and the double oven is 4,600kw making a combined total of 11,300kw. Consumer unit is 32amps for the...