I appreciate the explanations :). It has been extremely helpful! I have decided to elect the assistance of a electrician friend (who has the tools I need to trace it back properly) and he has apparently fitted one before so I can use the valuable knowledge you’ve provided to work out everything...
Thank you :).
I looks like L and 5 are linked with a red wire and then there is another red wire which I presume heads off to the PRT2 thermostat.
N, L, 3 and 4 are in use (excluding 5 for the above) and a single yellow wire goes into 3 which traces back from the thermostat (guessing as it’s...
I understand that this is being more complex and if the costs of install weren’t so high I’d probably go with that but I’m a good 75-80% sure of what I need to do. It’s literally just the room thermostat that is the sticking point as the other half wants it gone, so it would need...
The below photo shows the distant from the room thermostat and the programmer unit;
As this appears to be one in one with the Hive receiver plate, do I connect the two reds on 5 into a single end slot on the Hive plate;
And then disconnect all of these and remove the old thermostat...
My apologies, I shall keep the conversation to this thread. I wasn't sure on the rate of response, and as I was researching what I needed to do, I've found that quite a few others have been through this and succeeded and so I just needed to understand the odd bit here and there to piece...
Hello,
I am currently looking at installing a Hive heating and water system and have a Potterton Suprima 30 with an EP2002 programmer and a thermostat EP2 in the lounge. I have a second thermostat EP2 in the airing cupboard upstairs which is for the hot water and has a boost button (pictures...