Recent content by spudy

  1. S

    mk4 fiesta wishbone

    Hi , is the new ball joint pin the same diameter as the old one , has the anti-rattle spring ( if fitted ) on brake caliper been displaced ( are the caliper bolts tight ) , are the wheel nuts tight and on the right way round , you could try dis-connecting the drop-links and see if the noise...
  2. S

    Ford Mondeo Estate 2.0 120 BHP TDci 2009 MKIV

    It does sound like a drop link but you have already changed that , so recheck tightness of all nuts and bolts , check subrame mounting bolts , look for rust around bolts etc it can be an indication they are loose , try hitting the anti roll bar upwards where it mounts onto the the body( or...
  3. S

    combi bioler dhw heat x

    Hi Tony thanks for your reply , Just to check i have understood the low gas rate could be caused by a reduced flow through the primary heat x , which could be a slow pump or a restriction in the primary heat x . Instead of over heating and locking out the boiler is modulating down the gas...
  4. S

    mk4 fiesta wishbone

    Hi. the bolts should be ok the first thing to do is go over all the nuts and bolts and make sure they are really tight and all the washers are where they should be . Also check the anti-roll bar and drop link though wear in these would normally cause a knock on uneven road surfaces . One other...
  5. S

    combi bioler dhw heat x

    Hi, Dan Thanks, so the primary heat x could be blocking up, would that not cause the boiler to over heat as it did when the DHW x blocked up , i am not doubting your diagnostics i just like to understand if i can , regards....
  6. S

    combi bioler dhw heat x

    Hi, Dan thanks again , pretty sure the filter was removed after the flush and new DWH heat x and fernox filter were fitted . When you say low boiler input do you mean it could be the reason for the meter timing being out , regards....
  7. S

    combi bioler dhw heat x

    Thanks for the reply J, Its a bit of an unusual one the best way i can relate to it as a motor mechanic is when an engine is running ok but its not quite 100% and you can't put your finger on it . Its had a new heat x , flush and fernox T1 filter about 6 months ago ...
  8. S

    combi bioler dhw heat x

    Thanks for the reply Dan , by should be i mean not as good as it was and was wondering what the acceptable heat in heat out should be for this type of heat x . I've heard all about the keston bad rep but to be fair to this on its been ok so far , i know its struggling to reach the 35 deg c temp...
  9. S

    Scooter Running Problem

    Hi, since you have had the barrel and head off its best to go back to basics. so no 1 check compression you can do this by blocking spark plug hole with your thumb and have some one kick to the engine over on the kick start , you should be able to feel a good amount of pressure ( be sure not...
  10. S

    combi bioler dhw heat x

    Hi, new to the forum ( first post ) have tried to search but could not find the topic , so hear goes . I have a Keston C36 its about 7 years old and the hot water produced is not as good as it should be . I am wondering if the DWH plate heat X is not as good as it should be , the keston shows...
Back
Top