Recent content by sskryten

#catlad If i open the tiles up then I would be able to use and under cloak slate/board, a barge board may require more opening. Did not want to strip the complete roof to open up the tiles plus there is another verge at the back half which would be more work. Was hoping for a quick fix but...

#colind86 Thanks for the tip on the Ludlow plus. Still looks like i'll have to remove a number of tiles to extend the battens/under felt. Then use a under cloak board/slate before bedding down in sand and cement. If I go for the cut tile option it needs to be cut on the peak rather than the...

Ive found the ply on the back of the TD4000 is to flexible for EDPM, you will see all the joins/fixing holes etc. Is there a reason your opting for a warm roof? Does the roof need stripping off? Would insulation between and below the joists be better? If you opt for the warm roof with the...

Need a little help here. With all the bad weather we have been having water has been appearing through the wall below the gable end. Have attached a pic showing the Redland 49 tiles on the gable end. As you can see there is no over hang, they have just been bedded down to the brickwork (9" solid...

Sandtoft 20/20 tiles have a min pitch of 15 deg Now read the info on Velux flashings!!!! You have two options for flashings for the 20/20 tiles....the standard EDZ but the min pitch for these are 20 deg if you need a lower pitch use the EDW flashing kit, these can be used at 15 deg...