Recent content by stelford45

The BG man tested all the pressures and the flue gas analyser, which were all ok. I have phoned Halstead engineer who was supposed to get back to me to arrange a visit but never did. It's a bit out of his way about 60 miles away. Both electrodes were changed but not sure if they were adjusted...

He replaced both of them

As far as I know the BG never checked or cleaned the fan, he checked the flue. I'll have to ring them back tomorrow and request them to take a look at the fan etc. Many thanks for your time and knowledge.

It seem that this is the only error code coming up on the panel. Never happens on the hot water only on the CH. Don't think any of the ntc's have been checked or replaced. The BG engineer did say it worked better with the cover off!

The fault code lights LED 3 and 4 which is.. Lockout Flame Signal / Lockout After 5 ignition. Thanks

Hello I had a new Halstead Eden CBX 24 Installed about 3 years ago and it has been working well until recently it started with the error burner lockout. The hot water works fine and the CH works until it get's hot and when it re-lights it goes to burner lockout. So I called british Gas who...