Recent content by Steve 34

Thanks did as suggested and ran a cylce empty seems to be working fine will try a full cycle when we have enough dirty dishes

Hi my dishwasher is not emptying and the first 2 lights on the left are flashing any ideas as to the fault and possible fix please thanks

the lights flashing are 1 & 3 the pump is working up to the point where the rinse cycle is called for thanks steve 34

have a hotpoint aquarius wf541 when machine goes too empty i get the following fault Wash Enhance’ and ‘Rinse Hold’ and ‘Mini Load’ option indicator lights flashing on the control panel pipes all clear fitted new pump but problem persists any ideas please Steve M

Hi Thanks for the replies Distance - about 20-25m Cable -2.5mm t & e Protection via rcd Power supply - not sure of the type, 1 cable entering main fuse 2 tails exiting with a separate earth via earth rod No extraneous-conductive-parts in either shed or cabin

Hi I need to put in a supply for a log cabin, I have power to a shed nearby (10m away from the cabin) via 2.5mm inside plastic conduit. Can I take a supply from that or do I need to upgrade the whole supply to 4mm. The shed supply is taken directly from the consumer unit protected via a 15A...

Hello, I have just spent an hour going through old posts (which I should have done first) I am I right in assuming that I should do the following: Use the 40 amp trip in my CU (but change to 32amp) Use a 45 amp double pole switch located less than 1 meter from the oven Use 6mm2 cable...

Hello all, I just bought a new Indesit cooker (built under) and I am uncertain how to wire it in the cooker is rated at 5.2KW it has a double oven and grill. The instructions show wiring it with the hob but I have a gas hob which is wired seperately, so I need to wire it on its own. I have a...