Yeah they were still sealed in a wrapper.
I'm having more progress now with them I'm getting feedback on the walk test but only if in the exact position the sensor was in when I added it.
So I've just left them there for now to keep a check on them
Thanks I'm not sure what's going on maybe they're both faulty or not.
I cycled the power and deleted the serial number and re added them by pressing the tamper instead of the the auto learn and they both got recognised fine and added to a zone.
But when I go on display zone they both show closed...
Thanks Galaxy guy
They are both on yeah.
I like I say one paired 1st time and worked fine but then I took the cover off to adjust the sensitivity it and made sure both covers were secure but now that's stuck on tamper O/C.
But the other sensors not worked properly at all yet it paired ok but...
Hi guys.
I'm setting up my first wireless motion sensors (IRP18M)
I added them both and both got recognised and I named the zone etc.
I did a walk test and 1 was working fine but the other wasn't and I looked and it said Tamper S/C
So I took the battery out for a bit and went back to the working...
Isn't that cleared when you first put your code in after.
I think when you put your code in to stop the alarm you scroll though them and then ENT to continue.
I'm still going through all my settings so not fully up to speed also.
I have registered for the service and added my phone and tablet on a separate install.
It seems like I was relying on it all being automatic I didn't think I would need to adjust settings.
I'll look into that
Thanks again.
Thanks for that Galaxy guy that definitely sounds like something I'd want.
I have planned to mess around with my NodeMcu board this weekend when my trigger arrives and see what I could get from that.
I did have MQTT set up last year on a Pii for something else so could possibly use that.
You're...
Hi guys @WD40again @GalaxyGuy
Can I just ask you both a quick side question about the GX app.
How are you able to see things in the output tab did you have to enable something in the settings?
I've recently set the app up and it does connect and arm/disarm and report events but nothing appears...