Recent content by stevevalo

I see your sense of humour finally woke up.

yes, you are correct, I indeed did edit. I however edited before I read your post, you did not...

Oh dear, too early for you?

TLDR Phew, I read it. Thanks for the pointers.

That is a good question, is what was on before classed as decking?

So the builders that built this house in 1970 were potty? And the balcony that I used until I decided to replace it was unsafe? I'm only trying to replace something that stood for 47 years, and the house had planning permission with the balcony. If I can't replace it with composite then...

I have a Sammy TV connected to a Sammy sound bar with wireless Sub. I would like to be able to connect the TV to my Yamaha (none AV amp) which is 5 metres away on the opposite wall. What is the simplest/easiest way to achieve this?

Don't think I will be doing that, kind of defeats the purpose of composite decking.

Ok, so I got a 1/4 turn, 1/2 inch valve and replaced the one in the bar valve, no more drip. Case closed. Thank you

Update: Started commissioning sequence. My understanding is that the door should have traveled, from the fully open position, to just below the 1st magnet. However the door traveled all the way down to just above the 2nd magnet, the control panel then gave a long beep to indicated that the...

Thanks for that, it's also what I've been told, cheaper to replace the whole unit. But I think it's just the 1/4 turn on/off valve I need to replace on mine, hopefully.

Thanks for that but not to keen on these square edge boards, do you have any other recommendations?

Hi Tdw, that is more or less my understanding. I'm going to power off and back on, clean the sensor strip, check the connection of the strip to the Transmitter. Remove cover to access the commissioning button and carry out the commissioning sequence. Give up I've already had the motor fail...

It does have a safety strip on the bottom. I think if that gets triggered the light flashes a sequence of colours to identify what triggered the stop/error. And it isn't showing any error codes at the moment.

Yea, it's got magnets top and bottom on the frame and a wireless transmitter on the door. Changed batteries and it flashes when it passed the magnets.