Recent content by stooo

I appreciate what is being said, and without being rude I have all the PIR's wired in, no door contacts/sensors as was not advised they were needed and want this alarm to work in one manner or another. If it's not the right way then it working up to a point is better than nothing in my view.

So the control box will not allow entry to be activated by a PIR alone?

Thanks again for your continued responses. So are you suggesting I try zone 2 (which is my entry/exit zone) as Inhibited entry also?

Tried entry exit as Zone 2 & Zone 3 - to clarify my previous post. And on entry if zone 2 PIR was activated, OR Zone 3 - alarm would sound straight away. There are no contacts, just PIR's. I do not know what entry time is set at, from the manual I cannot see where it is changeable...

The programming was changed when they were swapped round. Zone 2 was set as entry/exit. Exit fine, entry alarm immediately went off, indicating Zone 2. Changed to Zone 3, took off Zone 2 from entry/exit. Exit fine, alarm immediately went off, indicating Zone 3. Tried with both...

Zone 1 is actually not where I want my entry/exit point to be, therefore changed it to Zone 2. Ideally i'd like Zone 2 and 3 to be entry/exit point if possible. Is there a solution, or does it mean rewiring?

It is a Veritas 8 with 6 PIR's. Zone 2 is the entry/exit zone. Have also tried with Zone 3 as entry/exit (disabling Zone 2 temporarily) with the same results. Hope this helps.

Have set up a Texecom Veritas alarm system (wired). All the walk testing, etc appears to be fine. Am having trouble with entry zones. Have checked and double checked the zone specified in the programming menu for the correct zone for entry/exit. Exit is fine, but on entry the alarm...