:D :D :D Just thought I'd update you. I could not see any evidence of dry jointing on the PCB but had a spot of solder put on every contact anyway. I was told by a store not to change the brushes as they where fine. Put everything back together and weh hey its spinning again. Tockworth you...
I have took the PCB back out and gave it to my father in law to inspect as he is an electronics engineer. the brushes, like I said have about 10 mm on them so i will replace them. I'll keep you informed. Thanks for taking the time to reply to my post it is really appreciated, Stranton
Hi again, right found pcb and on initial assesment it looks fine! I have also removed the brushes from the motor, there is about 10-12mm of length on them, is that ok or not?
Hi tockworth, thanks for the reply! I have took the front off, apart from the drum seal. In have removed what I thought is the pcb although I am now having doubts. What I have removed is what locks the door as I thought this is what you where talking about. It has three wires and the centre one...
I have a whirlpool AWM822 Washing Machine. The machine washes fine, aggetates fine and drains fine, though it will not spin! I initially thought it may be the load so I tried both a half load and no load at all. Both times the machine emptied fine but never spun. I have inspected the filter 3...