Recent content by stubo88

Hi , I've attached a couple of photos. The door on the right opens inwards. It clashes with the other door mostly at the top. I've tried to sand it down but I'm not sure if that'll work. Two sanding discs already used up and no joy. Foxhole, good point about the gap. I wish the builder that...

Hi, I have a wooden double door gate outside. It's full door height. Unfortunately with the wet weather it must have swollen as the doors are now hard to close (they clash slightly). Any advice on how I can fix that? I think I need to remove about 1 or 2mm from one of the doors. Thanks Stu

Thanks Harry, thanks Conny, So it sounds like screws are the best way forward then. I thought I might have to do 4 screws per slat. But doing 2 as you recommended Conny will save some work! Do I need to drill pilot holes in both the slats and the supports, or just the slats?

Hi I'm building some slatted airing cupboard shelves as a diy project. Total noob skill level. I've ordered the timber. Tulipwood, 44mm x 44mm for batons. 92mm x 24mm for slats. Shelves will be ~900mm deep, 8 slats per shelf. Width of shelf 820mm. There will be 4 shelves in the cupboard. What...