Thanks John
I have a spare bit of 10mm cable on a reel and it is the same size as that.
So fitting a 40A fuse into that Unit would not be a problem (other than getting it to fit!). I take it that its not a matter of putting a 40A fuse into the current 30A carrier but replacing the carrier...
I'm with you. In the garage it is in conduit clipped to the wall and then attached to rafters before disappearing into the wall - from there it probably goes between floor and ceiling clipped to the joists and into the shower room. There would be no insulation in the equation.
I take it this...
Thanks for the speedy response.
Not sure what you mean exactly but a 10mm cable runs from the CU straight to the shower which is nearly directly above where the meter box is?
Hope I can explain this properly :oops:
My electric shower (9.5kw) has packed in and upon inspecting the fuse, etc I noticed that it whilst it is running off its own CU (Memera 2000 ASN100 100A) and has 10mm cable it only has a 30A fuse. This shower was replaced about 5 years ago and a 30A...
Hi there.
I am having a fitted wardrobe put in meaning a socket will be made unusable so I want to move it to behind the wardrobe and access it via hole in back of wardrobe.
The socket has only one set of wires running to it so I presume I couldn't normally spur off it as it is a spur...