I am going to try to use a white flat ladder towel rail and cut down the brackets and see how that goes, the customer is selling the house and just wants it done, failing that we will look to a plinth heater.
Thank you guys.
Hi guys
Im really hoping somone can assist us in this issue, we are to swap some damaged slabs that were damaged during a tree falling over, we are to swap approx 12 slabs but are really struggling to locate some but the slabs in the correct size (850mm x 560mm) seem unattainable.
Hopefully...
Hi guys
I am in a bit of a situation, our joiner has installed a kitchen and there's a drawer unit and fillet piece to the wall there is 60mm clearance between wall and edge of the drawers, I have been looking at the following options
1-an old type radiator 600mm high x 400mm wide with no...
the hatches i find are designed to be concreted in on 4 sides and not heavy construction but as you see from photos my trenches are concreted on 2 sides and 2 sides are open and bridge over pipes etc i suppose im looking for the most suitable product or suggestions, hopefully someone has come...
Hi Guys
Currently working on a school and the service trenches flooded due to burst pipe so we are removing the vinyl and all associated timber and replacing with new on a like for like basis, around 10 years ago the last contractor removed all the access hatches (Nice heavy duty brass ones)...
Hi guys
I have knocked through my hallway wall into the garage and in the process of installing a fire door, I have the door 762mm (30") wide fd30 and a rebated fire rated frame and strips also rated self closing hinges, just after some advice on what to set my frame width at and how much space...
Hi guys
Today's project has turned into a can of worms lol
I broke a tile and a ridge tile and struggling to Identify them, my neighbour says he thinks they are a marley but he's not sure, hopefully someone on here can help me identify them
Regards
Hi guys I'm just redoing my fascias and soffit and decided to go for the above mentioned caps over my cemented verge, I have cut back my tiles by 30mm to allow the trim to sit flush and reading some instructions it says to remove all old mortar, my question is is this necessary? Can it be left...
Hi guys
I have had the house 3 years and finally got round to this job, I have been avoiding it and now it's time to sort it.
the house is approx 27 years old and the 2 concrete lintels that support the inner and outer skin of the front of the house is in my opinion very inadequately supported...
hi guys
if you had to design a heating system what software would you use? I have seen some done by you guys in the past posted on here and could do with one right now
regards