Recent content by t3rm3y

Thanks, yeah I think timer frame and then cladding to keep waterproof sounds like I was thinking, just wanted some advice from people with experience/ knowledge .

Hi 23vc, we have a external wooden lean to at the door house backdoor enters this lean to, that has its own door to get outside, we are replacing it with a new sunroom type lean-to, so will go on existing concrete. As it's a little smaller we wanted to put a simple weather proof frame up...

Hey all, We have a simple sunroom to replace an old timber outbuilding. It's attached to the wall currently, the new sunroom is slightly smaller, what can we add in between the wall and sunroom to extend it out about 20cm and remain waterproof and not allow any leaks.

Yes I get that, but surely the updraft is created by both fans pulling air into the vent instead of one pulling in and other blowing out in to the hood, means the left side of the hood isn't sucking up the cooking air/steam etc , only the right side.

Here's a link to the model. The image clearly shows air intake (sucking air in) on the left and right side, but my motor is definitely sucking air on the right but blowing air on the left side., I think it should be sucking air too into the central vent so it goes up...

Hi, no it's on a wall that's internal, so can only recirculate. I'll try and find it. It was just a 90 cm cooker hood. Nothing fancy. "Ciarra" is brand.

We can't have it extracting to outside, it has an option of recirculating or extraction. We are using it in recirculating mode.

The kitchen was put in last year. The extractor is very loud, it's recirculating , and I noticed that the fan on the right side sucks air in, this has a charcoal filter. The fan on the left side is blowing air out, which seems weird design as the vent is in-between both fans., if I put a filter...

What would be the wire colour for this so I can check the wiring? Or is it likely a device fault that would lose signal?

i cant drain down and replace pipe work, im happy to remove the actuator and replace and wire like for like.

yea, clicking. about once a second yeah.

hi, just an update to say i have heard it ticking as well, so right now, the hot water is on, heating is off. the HSA3 is ticking, and the radiators are heating up . should i just replace it unit? or get a better one (whats better but same wiring)?

Hi, read a few posts with varying faults on these actuators. Mine seems to call for CH when only the water is on so the rads are heating up. And it also seems to be overheating the rads and water when both are being called for. (I think that's tlwhats happening anyway, rads get extremely hot...

Ok, so I just get a tin of tar adhesive and stick a piece of felt over the peak onto the newly laid felt?

I replaced the felt on the shed roof as it had torn during winter and was damaged. The roof panels had also bowed a bit I guess just due to lack of support in the shed. I had the overlap in the middle and used the recommended nails to tack it all down, but the peak is terrible as the roof bows a...