Recent content by T786

I don't know what you mean when you say 25/60. But the house gets very hot in 10 - 15 mins. The hot water in approximately 20 minutes. The ufh can take a little longer but I imagine that is due the the span of the pipe?

Blue pump was not changed. Red pump got taken off and re installed with venting bottles.

I have finally managed to get someone who has sorted all the issues and my system is working perfect. Cold mains increased to 28mm Y plan heating system changed to S plan with UFH as a separate zone CH as a separate zone Separate thermostat for UFH and separate for CH Did not have to change...

I agree, in the current pandemic it is hard to find anyone reliable.

Hi I tried this and it made little or no change. Where would I install the low loss header? The cyclinder is approximately 100 sq ft away from the boiler. Where would I install the manifold and thermostat to this now? Next to the boiler or in the UFH room?

Hi yes it does help, I will try that and let you know of the outcome

I have not got the manual to look up the codes. The water does heat with the boiler with no issues at all. I have attached some photos of the pump and the cyclinder.

It is the ecotec 428

No it never worked properly

Thank you for the response. It was done through a builder, not sure on the qualifications side. It has not been maintained annually. Even with the UFH completely turned off all the rads do not heat up

Hi, I have a couple of problems with my heating system. I have a detached house in crosland moor, huddersfield that is approximately 3000 sq ft and is currently running on a 2014 Vaillant ecotec 28kw boiler. The central heating system was a gravity fed system which was upgraded to a Unvented...